Beer leaves a film inside lines and taps. Over a few weeks that film becomes food for bacteria and wild yeast, and a layer of yeast and protein builds up. The first beer of the day tastes stale or a little buttery, and the problem gets worse until someone notices.
How often
- Every two to four weeks, or
- Every time you change a keg, whichever comes first.
If you only drink a keg occasionally, clean the lines when you put a new keg on. Lines left full of beer and unused for weeks are the worst case.
What you need
- Beer line cleaner, an alkaline cleaner designed for the job. Mix it at the strength on the label.
- A way to push it through the lines — a hand-pump cleaning bottle, or a spare keg that you fill with cleaning solution and connect like a normal keg.
- A tap brush and a small brush for disconnects.
- Clean water for rinsing, and sanitiser for the final pass.
The routine
- Disconnect the keg and remove the beer disconnect.
- Connect your cleaning bottle or cleaning keg to the beer line.
- Push cleaning solution through until it comes out of the tap. Then stop, and let it soak in the line for 15 to 20 minutes.
- Push through more solution to flush out what the soak loosened.
- Rinse with clean water until there's no trace of cleaner — taste the water from the tap to be sure.
- Push through sanitiser, or simply reconnect a keg and pour off the first glass.
While the line soaks, clean the tap and disconnect.
Clean the tap properly
Taps are where gunk hides. Every month or two, take the tap apart — most home brew taps come apart by hand or with a simple spanner. Soak the parts in cleaning solution, scrub them with a tap brush, rinse and reassemble.
Forward-sealing taps seal at the front of the tap, so beer doesn't sit in the tap body between pours. They stay cleaner and don't stick the way older rear-sealing taps can. If your tap sticks after a few days without use, it's probably a rear-sealing design that needs cleaning more often.
Disconnects and posts
Beer disconnects have a small poppet valve that traps beer. Take them apart occasionally and soak them. While you're there, check the O-rings on the keg posts and replace any that are cracked or flattened.
Beer stone
Over time, a hard mineral deposit called beer stone can build up inside lines and taps, especially with hard water. Alkaline cleaner doesn't remove it well. An occasional pass with an acid-based cleaner does.
When to replace lines
Beer line doesn't last forever. Replace it:
- At least once a year.
- If it's stained, cloudy or smells even after cleaning.
- After an infection — you'll never fully clean it out.
- When you switch from a strongly flavoured beer, like a heavily hopped IPA or a smoked beer, to a delicate one, if the flavour seems to linger.
Barrier-style lines resist staining and flavour carry-over better than plain vinyl and are worth the small extra cost.
Keeping your tap honest
A clean system pours a clear, well-carbonated beer with a stable head from the first glass to the last. If yours doesn't, check in this order: line cleanliness, beer temperature, carbonation pressure and line length. If you're stuck, bring the details in and we'll help you sort it out.
Line cleaning kit
- Beer line cleaner, mixed to the dilution on the label.
- A hand pump bottle, or a spare keg kept for cleaning.
- A tap brush and a small brush for disconnects.
- No-rinse sanitiser for the final pass.
- Spare beer line and O-rings for when it is time to replace them.