"Gravity" is shorthand for specific gravity — how dense the wort or beer is compared with water. Sugar makes wort denser than water. As yeast turns sugar into alcohol, which is less dense than water, the gravity falls. Measure it at the start and end and you can see what happened.

The hydrometer

A weighted glass float with a scale in its stem. It floats higher in denser liquid.

How to use it:

  1. Fill a trial jar with a sample of wort or beer. Don't put the sample back in the fermenter afterwards.
  2. Lower the hydrometer in and give it a gentle spin to knock off any bubbles clinging to it. Bubbles lift it and give a falsely high reading — a common problem with fermenting beer.
  3. Read at eye level, at the bottom of the curved surface of the liquid (the meniscus).
  4. Check the temperature of the sample and correct if needed.

Temperature correction

Hydrometers are calibrated for one temperature — usually 20 °C, sometimes 15.5 °C. Check yours. Warmer samples are less dense and read low.

For a hydrometer calibrated at 20 °C, add roughly:

Sample temperature Add to the reading
25 °C 0.001
30 °C 0.003
35 °C 0.004
40 °C 0.006

Above that, cool the sample before reading. It's more accurate than correcting a hot reading. A sealed container in the freezer for a few minutes does it quickly.

Check the calibration by floating the hydrometer in distilled water at its calibration temperature. It should read 1.000. If it doesn't, note the difference and allow for it.

The refractometer

A small optical instrument that measures how much a few drops of liquid bend light. More sugar, more bending.

Good: - Needs only a few drops, so you lose almost no wort. - Fast, and cools a sample in seconds on the glass. - Perfect for brew day — checking pre-boil gravity, first runnings and the boil.

How to use it:

  1. Calibrate it with a drop of distilled water. Adjust it to read zero.
  2. Put two or three drops of wort on the glass, close the cover and wait a few seconds.
  3. Read the scale through the eyepiece, pointing it at a light.

Most refractometers read in Brix, a sugar scale. To convert wort to gravity, first divide the Brix reading by a wort correction factor, usually about 1.04, to get degrees Plato. Then multiply by four to get roughly the gravity points — so 12 °P is about 1.048. Brewing software and refractometer calculators do this for you.

Choose one with automatic temperature compensation so warm samples read correctly.

The refractometer trap

Once fermentation starts, a refractometer gives wrong readings. Alcohol bends light too, so a plain reading of fermenting or finished beer looks much higher than it really is.

You can still use one, but you need a correction calculator that takes your original reading and your current reading and works out the true gravity. Those calculators are close, but not perfect. For a final gravity you're going to rely on — especially before bottling — a hydrometer is the safer tool.

Which to buy?

  • Starting out: a hydrometer and trial jar. It's cheap, it works at every stage, and it never needs an alcohol correction.
  • Brewing all grain: add a refractometer for brew day. Use it for pre-boil and original gravity, and use the hydrometer for final gravity.
  • Both is the best answer if you brew regularly.

Floating digital hydrometers

Wireless digital hydrometers sit in the fermenter and send gravity and temperature readings to your phone. They're great for watching a fermentation's progress without opening anything. They need calibrating, and their absolute accuracy is usually within a couple of points — so confirm the final gravity with a hydrometer before bottling.

Working out alcohol

ABV ≈ (original gravity − final gravity) × 131.25

A beer from 1.050 to 1.010 is about (0.040) × 131.25 = 5.25 percent. Close enough for home brewing.

Keep a record

Write down every reading — original gravity, pre-boil gravity if you brew all grain, and final gravity — and the temperature. Over a few batches, the numbers tell you how your process behaves and make problems much easier to spot.

Measuring gear worth owning

  1. A hydrometer and a tall trial jar.
  2. A thermometer, for temperature correction.
  3. A refractometer with automatic temperature compensation, for brew day.
  4. Distilled water, to check calibration.
  5. A notebook or app to record every reading.