Brew in a bag — BIAB — strips all grain brewing back to its essentials. Instead of a mash tun and a separate sparge, you mash the grain in a fine mesh bag inside the same pot you'll boil in, then lift the bag out. One vessel, no extra gear, and a beer that's genuinely all grain.
Most people do it in a 40 litre urn for a full 23 litre batch. But you can do a smaller batch on the stove you already own, and it's the cheapest way we know to find out whether all grain brewing is for you.
Why a smaller batch
A typical household burner struggles to bring more than about 15 to 18 litres to a rolling boil. A full 23 litre batch needs around 30 litres of water, which is beyond most stoves and most stockpots.
So size the batch to the kitchen: about 10 litres into the fermenter. That's roughly 25 stubbies or 13 long necks. Small enough to handle safely, big enough to be worth the day.
The gear
- A stockpot of 19 to 25 litres. Stainless steel, with a lid. If you have an induction cooktop, check it's induction-compatible.
- A fine mesh brewing bag sized to the pot.
- A digital thermometer you trust. Check it in iced water (it should read 0 °C) and in a rolling boil (close to 100 °C on the coast).
- Kitchen scales, plus a small scale reading to 0.1 g for hops.
- A hydrometer and trial jar.
- A fermenter — ideally a smaller one. A 10 litre batch in a 30 litre fermenter works, but there's a lot of headspace.
- No-rinse sanitiser.
- An oven rack, a strong colander or a pulley to rest the bag on while it drains.
A 10 litre pale ale
| Amount | |
|---|---|
| Pale ale malt | 2.0 kg |
| Wheat malt | 150 g |
| Light crystal malt | 100 g |
| Galaxy hops, 60 minutes | 5 g |
| Galaxy hops, 10 minutes | 10 g |
| Galaxy hops, off the heat (whirlpool) | 20 g |
| Galaxy hops, dry hop | 20 g |
| Clean ale yeast | One 11.5 g sachet |
At around 70 percent efficiency this lands at about 1.048 original gravity and 30 IBU, finishing near 4.8 to 5 percent ABV. Ask for the grain crushed for brew in a bag.
Water
You need about 16 litres in total. That covers 10 litres into the fermenter, about 2.5 litres soaked up by the grain, 2 to 3 litres lost to evaporation in a stovetop boil, and about a litre of hop and trub left in the pot.
Treat the water with a quarter of a campden tablet. If you're keen, add 3 g of gypsum and 1 g of calcium chloride — the water profile guide explains why.
The brew day
1. Heat the strike water. Bring all 16 litres to about 68 °C. With so much water relative to grain, the temperature only drops a degree or two when the grain goes in.
2. Mash in. Fit the bag in the pot with the top folded over the rim. Pour in the grain slowly, stirring well to break up dough balls. Check the temperature in a few places after five minutes. You're aiming for 66 °C.
3. Hold for 60 minutes. Lid on, heat off, and wrap the pot in an old blanket or towels. Check after 30 minutes. If it has dropped more than a couple of degrees, put it on low heat, stirring constantly and keeping the bag off the bottom of the pot so it can't scorch.
4. Lift the bag. Raise it out and let it drain over the pot on an oven rack or a colander. It'll be heavy — around 4 kg of hot wet grain. Squeeze it gently with gloves or two plates. The old warning about squeezing releasing tannins hasn't held up; squeeze away.
5. Take a reading. Stir the wort and take a gravity sample. Write it down. This is your pre-boil gravity.
6. Boil for 60 minutes. Bring it to a rolling boil, uncovered. Add the first hops as it starts boiling, and the second addition ten minutes before the end. Watch closely as it comes up to the boil — wort foams up and boils over without warning.
7. Whirlpool. Turn off the heat, let it settle below about 80 °C — five minutes or so — then add the whirlpool hops and stir. Leave the lid on for 20 minutes.
8. Chill. This is where a small batch shines. Put the lidded pot in a sink full of iced water and stir the water around it. Change the water as it warms. You should be under 25 °C in 20 to 30 minutes.
9. Transfer and pitch. Pour or siphon the cooled wort into a sanitised fermenter, leaving the sludge behind. Splash it in — the yeast needs oxygen at this stage. Take an original gravity reading, then sprinkle the yeast on top.
10. Ferment. Keep it around 18 to 20 °C. Add the dry hops after about five days, when fermentation has slowed, and bottle or keg once the gravity has been steady for three days.
Troubleshooting
The gravity came in low. Usually the crush — make sure it was milled for a bag. Also check that you stirred the wort before sampling and that the sample was cooled to 20 °C before reading. A stovetop BIAB batch often lands nearer 65 percent efficiency than 70 the first time. Add 200 g of grain next time, or top up with a little dry malt extract in the boil.
The temperature fell during the mash. Wrap the pot better, or put it in an oven that's been warmed to around 70 °C and turned off. Gentle heat with constant stirring also works.
The boil wouldn't stay rolling. Partly cover the pot to help it along, but leave a gap — a fully covered boil traps compounds you want to drive off. Straddling two burners helps on gas.
It boiled over. Every brewer does it once. Keep a spray bottle of water handy; a quick spritz knocks the foam down. Turn the heat down as the boil begins, and only turn it back up once the foam has settled.
It took forever to chill. Use more ice and keep the water moving around the pot. Stirring the wort itself, with a sanitised spoon and the lid off for short periods, speeds things up considerably.
Other beers from the same method
The method doesn't change, only the recipe. A few easy variations at the same 10 litre size:
- Golden ale — 2.1 kg pale malt, 100 g wheat malt, a single 10 minute hop addition, and a clean ale yeast.
- Amber ale — 1.9 kg pale malt, 200 g medium crystal, 50 g dark crystal, and a more restrained hop schedule.
- Dry stout — 1.8 kg pale malt, 200 g roasted barley, 200 g flaked barley, bittered to around 35 IBU.
Recipe software will scale any 23 litre recipe down to 10 litres. Check the hops after scaling — small batches boil more vigorously, so hop utilisation can run a little higher.
Cleaning up
Empty the spent grain into the compost or green bin — chickens love it. Hose out the bag, turn it inside out and let it dry fully before storing, or it'll go mouldy. Clean the pot with a percarbonate cleaner while it's still warm and the sticky residue comes off easily.
Safety
- Hot wort is heavy. Sixteen litres weighs 16 kg. Don't lift a full pot of hot liquid if you can avoid it.
- Check your cooktop's weight limit. Glass and ceramic cooktops have one, and a loaded stockpot can exceed it.
- Run the rangehood. An hour's boil puts a lot of steam into a kitchen.
- Keep kids and pets clear while you're lifting the bag and moving hot liquid.
Stovetop BIAB shopping list
- A 19–25 litre stockpot, induction-compatible if your cooktop needs it.
- A fine mesh brewing bag that fits the pot.
- An accurate digital thermometer and a hydrometer.
- Grain crushed for brew in a bag — tell us it is for a bag.
- A fermenter that suits a 10 litre batch, and no-rinse sanitiser.
Where to next
If you enjoy it, the natural step up is a 40 litre urn or an all-in-one electric system for full 23 litre batches. Everything you learned on the stove carries straight over. Bring your notes in and we'll help you work out which way to go.